SWX500
The motion-dial is as follows.
- Trigger_pull forward or back the trigger (it doesn’t synchronize with the hammer).
- Hammer_cock cock or release the hammer (it doesn’t synchronize with the trigger).
- Cylinder_stop/Down up or down the cylinderstop-latch (it doesn’t synchronize with the trigger).
- Bolt_forward/back forward or back the cylinder release bolt(and Thumbpiece)
- safety_key_lock lock or unlock the safety-lock
- Yoke_swing-out the cylinder is taken out left
- Cylinder_rotate rotates the cylinder( When the value:1, it rotates by 72 degrees. )
- Extractor_push forward or back the extractor
- Center_pin_forward/back forward or back the cylinder-center-pin
This product is tested only with Windows-PC.
This product is tested only with Poser. ( NOT tested with “DAZ|Studio” )
Download from QtyFiles Service